I am fighting an epic battle for my life against my overwhelming desire to scrap this and try again because the topology isn't quite right and I'm getting lumps when sculpting.
I did actually have a very quick go at redoing it earlier with edge modelling rather than extrusion and ended up with a similar-but-different thing with a different problem that I couldn't resolve so I came back to this one because while the topology of the other one was better this one was quicker and I couldn't figure out how to resolve the problem that cropped up with the other one
It looks and sculpts/adjusts fine with multires so it will work fine.
IT WILL BE FINE.
This is about as good as I'm going to get with this travesty.
notredoingitnotredoingitnotredoingit
It will be fine once I start sculpting.
this is late because I realised it was after midnight when I finished so I figured I'd post this morning and of course have been flat out since
This post also appears on my blog.
Want a cameo character? If you interact frequently with me here (either on my posts or your posts or better yet both!) or on one of the linked Discord channels, all you have to do is let me know and tell me what you'd like :) Everything you need to know is (probably) here and if it isn't just ask (sorry the link goes offsite to my blog where the layout is how I want rather than the one here which is only here because the original one was).
Thanks for looking! ^_^
Congratulations @ryivhnn! You received a personal badge!
Wait until the end of Power Up Day to find out the size of your Power-Bee.
May the Hive Power be with you!
You can view your badges on your board and compare yourself to others in the Ranking
Check out our last posts:
Congratulations @ryivhnn! You received a personal badge!
Participate in the next Power Up Day and try to power-up more HIVE to get a bigger Power-Bee.
May the Hive Power be with you!
You can view your badges on your board and compare yourself to others in the Ranking
Check out our last posts: