FDM 3D printing is a tricky thing. You want your plastic to be very hot to squeeze it through the nozzle easily. But as the filament leaves the nozzle and gets deposited you want it to cool and solidify as soon as possible to prevent layer deformation and sagging. This is especially true for PLA plastic. A part cooling fan is meant to do just that. It is virtually impossible to print any fine-detailed PLA part without good cooling.
Here are some pictures to illustrate my point. Both parts were printed on the same 3D printer with the same settings. I literally ran the same GCODE twice. The only difference is that the part cooling fan was off during the first print. It is exactly the case where a picture is worth a thousand words. See for yourself!
nice!
Thank you!
Print speed is very important.
It makes a big difference especially for the outer perimeter to let it cool down more for steep overhangs.
The time per slice can help a lot on the speed corner: 15 seconds is a good value to start with.
You are absolutely right! Although 15 seconds seems to be a bit extreme. 5 seconds per layer seem to work fine for me...
I know it seems a lot but with 15 seconds it works for nearly any geometry: including small miniatures and also high throughput printing with 0.8mm nozzle.
Dear frnd @beetlevc
An useful information about 3D painting. Thanks for yourl Helping Nature.
Congratulations @beetlevc! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
Click here to view your Board of Honor
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
You got a 5.39% upvote from @emperorofnaps courtesy of @sabari18!
Want to promote your posts too? Send 0.05+ SBD or STEEM to @emperorofnaps to receive a share of a full upvote every 2.4 hours...Then go relax and take a nap!
Congratulations @beetlevc! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
Click here to view your Board of Honor
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
hello @beetlevc , I follow you in mining SP, how many people do we upvote in a day?
Hey @rhampagoe! Thank you for following me. Contact me on Discord beetlevc#8302
Ok @beetlevc I have added you as a friend in the discord
okay!
Congratulations @beetlevc! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
Click here to view your Board of Honor
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
Congratulations @beetlevc! You have completed the following achievement on the Steem blockchain and have been rewarded with new badge(s) :
Click here to view your Board of Honor
If you no longer want to receive notifications, reply to this comment with the word
STOPDo not miss the last post from @steemitboard:
STOP
Notifications have been disabled. Sorry if I bothered you.
To reactivate notifications, drop me a comment with the word
NOTIFYThanks for sharing such valuable info regarding 3d printing. Keep writing such blogs
www.makenica.com