Acompañame a hacer manualidades con foami / :D
Join me to make handicrafts with foami
Como materiales usaremos:
- Foami o goma eva de color amarillo, verde y marrón.
- Tijeras, silicón, y un color naranja.
Hi!! I've been making decorations for my birthday which has a sunflower theme (my favorite flower) and I wanted to share with you a little bit of how I made these little foami flowers.☝️
As materials we will use:
- Foami or eva rubber in yellow, green and brown.
- Scissors, silicone, and an orange color.
☺️
¡Comencemos! / let's start!
- 1 : We make a mold in paper with the shape of an star but with 6 points, and we mark over the yellow foami.
2: We cut out our figures and with an orange color we paint over the foami from the middle to the tips.
3: with an iron, it can be a clothes iron or a hair iron like the one I am using, we heat it to the maximum, and we make pressure tip to tip of our figure until it gets hot.
4: When the foami is hot, we make a pressure with our fingers as shown in the image.
5: We repeat this with all the tips and with all the figures until we have a shape like the one shown in the image and we continue to arrange and glue two by two, one on top of the other.
Following the image aside: ←
- 1: We cut from the brown foami strips of approximately 1cm wide.
- 2: We make small cuts all over the strip as shown in the picture.
- 3: Roll up with the cuts facing upwards.
- 4: We open well the small cuts to give it shape.
- 5: And finally we glue in the middle of our flower.
Following the image aside: ←
- 1: In the green foami we trace small leaves and cut.
- 2: We do the same procedure of heating with the iron.
- 3: when it is warm enough we flatten it as shown in the picture.
- 4: arrange around the flowers and glue underneath.
And that's it, we have cute self-made foami sunflowers! :D
- 1: Hacemos un molde en papel de forma de etrella pero con 6 puntas, y marcamos encima del foami amarillo.
2:Recortamos nuestras figuras y con un color naranja pintamos encima del foami de medio a puntas.
3: con una planca, puede ser de ropa o de cabello , la calentamos a lo mas miímo, y hacemos presión punta po punta de nuestra figura hasta que se caliente.
4: Cuando esté caliente ya el foami hacemos una presión con nuestros dedos como se ve en la imagen.
- 5: Repetimos eso con todas las puntas y con todas las figuras hasta que nos queden con forma como la que se muestra en la imagen y proseguimos a acomodar y pegar de dos en dos, una encima de otra.
Siguiendo la imagen de arriba:☝️
- 1:Cortamos del foami marrón tiras de aproximadamente 1cm de ancho.
- 2: Hacemos pequeños cortes por toda la tira como se ve en la imagen.
- 3: Enrrollamos con los cortes hacia arriba.
- 4: Abrimos bien los pequeños cortes para darle forma.
- 5: Y finalmente pegamos en el medio de nuestra flor.
Guiandonos de la imagen de arriba: ☝️
- 1: En el foami verde trazamos pequeñas hojas y cortamos.
- 2: Hacemos el mismo procedimiendo de calentar con la plancha.
- 3: cuando este lo suficientemente calliente aplastamos como se ve en la imagen.
- 4: acomodamos al gusto al rededor de las flores y pegamos por debajo.
¡Y listo, tenemos lindos girasoles de foami hechos por nosotros mismos! :D
Gracias por leer /
Thanks for reading.
Congratulations @misgleibethperez! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
Your next payout target is 50 HP.
The unit is Hive Power equivalent because your rewards can be split into HP and HBD
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOP