Hello hive motors friends ,Today I will tell you about the charging and electrical systems on motorbikes as well as travel that often occur in the area.
Electrical components and charging on the motor:
•motor spool
•kiprok
•battery
•motor body cable
Above that are some of the components of charging as well as electricity on the motor for problems that often occur, usually the motor has difficulty turning on, the lighting is not optimal and the battery often dies.
1.Motor spool
The motor spool is a charging component that directly leads to the motor battery if the motor spool is damaged, the signs that can be immediately seen are first the motor battery has dropped, then the motor is difficult to turn on, the charging is not optimal and the electrical current is unstable.
>How to check for damage to the motor spool
•first you have to disassemble the left side of the motorbike, to see if the spool is burnt or not. if one of the motor spool coils is burnt you can be sure you have to replace it with a new one or replace the dynamo coil.
•The second way, you have to look at the cable connection from the motor spool that leads directly to the motor battery. check if there is a burn or not, because if the motor spool is damaged automatically the connection cable will be damaged or burnt
2.Kiprok
The function of the kiprok itself is to stabilize the current coming from charging to the motor battery, it can be ascertained that if the kiprok is damaged then the current flowing to the motor battery is unstable and has excess charging for how to fix it yourself You have to buy a new kiprok because it is very difficult if have to fix it.
3.Motor Battery
The most important component in motor electricity is the motor battery. because this is the source of electricity obtained by the motor. this component must be stable and in good condition so that the motor can be used optimally, many problems that can occur in the motor battery are usually caused by improper use and unstable charging by excessive current, therefore other components such as motor spools and kiprok must be ensured that it is in good condition so that there is no damage to the motor battery.
4.Motor body cable
For the motor body cable, it is very mandatory to be in good condition and there is no peeling skin of the cable because the function of this cable is to deliver electric current from the battery to other components, this part must also be considered because if there is a wire that is scratched this can cause a short circuit. on the electrical of the motor so that it causes the motor to short out and not start, it is very important to pay attention to it, my friend.
Maybe that's my discussion this time about how to care and charge the battery on a motorbike.Thank you very much for reading my article. I hope it will be useful for all of you. I "angga redhava yuzan" permission to resign, that's all and thank you.
Congratulations @anggayuzan! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
Your next target is to reach 800 upvotes.
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOPCheck out the last post from @hivebuzz:
Support the HiveBuzz project. Vote for our proposal!
hello friend, very good information about the maintenance of your bike.
Thank you,@gregcoin hope this information can add to your insight.