Beautiful Origami Anthurium Flowers & Leaves

Hello Everyone!
I make Anthurium flowers and leaves today. I make them by folding paper. There are many steps to fold the paper for that flower. For the leaves, it's easy and few steps. I make three flowers and leaves. So need to fold a lot of paper. I have never made like those flowers and leaves. It is made using only colored paper. Write with texts and there are pictures of each step on how to fold them.

Needed materials
colored paper
glue
scissors
pen
ruler

In the first step, the paper for the flower is cut by equal length and width with 8cm. Fold the paper in half and slightly fold the two opposite corners. I've drawn two lines to show how to fold each of those corners. Fold the corner of the other side about 2cm away from the center. Fold the paper in half. Draw two lines in the middle and fold it step by step according to those lines. Fold a roll of green paper and attach with a piece of yellow paper on one side as shown. Fold the top of the yellow paper as shown. Attach it with the red paper to form the Anthurium flower.

For the leaves, the paper should be cut by the same length and width with 16cm. Fold it in half and fold both sides to the middle line. Fold the edge from the other side. Fold the paper in half and draw lines. It should be folded in the same way as the flower. Fold the two edges as well. I have outlined this area. Attach and glue it with a roll of green paper.

In the same way, three flowers and leaves are made. I really like them because they look so pretty after I made them. But it takes long time and patience for them. I also take beautiful pictures. Thank you so much for your reading my post to the end.