[Spanish] Una casita nueva para mi cactus.🌵 [English] A new house for my cactus.🌵

in GEMS3 years ago (edited)
Hola hola mi amigos de hive hoy les presento un paso a paso, pues antes de hacerlo fui hacia mis cactus a regarlos y como de costumbre se me ocurrió una gran idea; Quise póstear uno de mis cactus, ya estaba muy descuidado con muchos hijos a su alrededor y para darle mejor apariencia y un toque diferente con el uso de materiales reciclables.

Hello hello my friends from hive today I present a step by step, because before doing so I went to my cacti to water them and as usual I came up with a great idea; I wanted to poster one of my cacti, it was already very neglected with many children around it and to give it a better appearance and a different touch with the use of recyclable materials.

20210607_001312.jpg

Le hice una pequeña carreta como casita para verlo más coqueto; A continuación le mostrate los materiales que utilice y cada uno de los pasos.

I made a small cart as a little house to see it more flirtatious; Below you show the materials you use and each of the steps.

• Recipiente de margarina.
• 2 tapas de botellas de aceite.
• Palillo de altura.
• 10cm de alambre.
• Marcador negro.
• Silicón caliente.
• Retazo de hoja en blanco.
• 2 retazo de foami o goma eva verde y naranja.

•Margarine container.
• 2 oil bottle caps.
• Height stick.
• 10cm of wire.
• Black marker.
• Hot silicone.
• Blank sheet scrap.
• 2 piece of green and orange foam or foam rubber.

20210606_194329.jpg

PASO 1: Con el alambre hice un agujero a cada tapa, pegué mis dos tapas e inserte el alambre y doble al rededor de las ellas, luego volví a doblar ambos extremo de sus puntas hasta quedar de la siguiente manera.

STEP 1:
With the wire I made a hole in each cap, I glued my two caps and inserted the wire and folded around the ellass, then I doubled both ends of their tips until they were as follows.

20210606_194618.jpg

20210606_194732.jpg

20210606_195223.jpg

20210606_195440.jpg

Paso 2: Piqué el palillo de altura, dos de 3cm, uno de 2cm y dos de 5cm. Le apliqué un toque de silicón caliente en casa una de las puntas de los palillos y lo adheri en el envase en la parte inferior; pegué en sus extremos los dos de 3cm y cerca de lo q simula ser la rueda le coloque el palillo de 2cm y en la parte superior hice dos agujeros y coloque los dos de 5cm para darle la mejor vista.

Step 2:
I chopped the toothpick in height, two of 3cm, one of 2cm and two of 5cm. I applied a touch of hot silicone at home to one of the tips of the toothpicks and attached it to the container at the bottom; I glued the two 3cm at its ends and near what simulates the wheel I placed the 2cm toothpick and in the upper part I made two holes and placed the two 5cm to give it the best view.

20210606_195545.jpg

20210606_200025.jpg

20210606_200812.jpg

20210606_200902.jpg

PASO 3: Después marque todo el al rededor de el envase y su rueda.

PASO 3:
Then check all around the container and its wheel.

20210606_201340.jpg

PASO 4: Luego recorte 3 cactus de el foami o goma eva verde y el retazo naranja lo pegué sobre la hoja en blanco y dibuje el logo de hive blog lecoloque un poco de silicón caliente y los pegue de la carreta.

STEP 4:
Then cut 3 cacti from the green foam or eva rubber and the orange scrap I glued it on the blank sheet and I drew the hive blog logo, place a little hot silicone on it and glue them from the cart.

20210606_205026.jpg

Por último, saque a mi cactus y lo introduje con su tierra de abono dentro de la carreta, y como pueden apreciar así es como quedó.

Finally, I took out my cactus and put it with its compost soil inside the cart, and as you can see, this is how it turned out.

20210606_205222.jpg

20210607_001332.jpg

Espero les haya gustado y me ayuden a compartir mi post, gracias que Dios me los bendiga🙏; Y a todos aquellos hivers que desde ayer empece a seguir espero tambien les guste, @acidyo @ocd @upmewhale @appreciator @livegaming.

I hope you liked it and help me share my post, thank you God bless you🙏; And to all those hivers that since yesterday I began to continue I hope you like it too, @acidyo @ocd @upmewhale @appreciator @livegaming .

Sort:  

Congratulations @renecampos8812! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :

You received more than 10 HP as payout for your posts and comments.
Your next payout target is 50 HP.
The unit is Hive Power equivalent because your rewards can be split into HP and HBD

You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word STOP