Kako je zahladilo tako mi je poceo otkazivati senzor radilice (rpm sensor/crankshaft sensor) pa je na red dosao novi. Posto sam ga odlucio sam promjeniti, a na internetu nisam nasao previse korisnih informacija odlucio sam napraviti ovo uputstvo u slucaju da netko bude imao isti problem.
Simptomi loseg senzora su zdravo anlasovanje/verglanje, ali ne zeli upaliti. Jos jedan od simptoma koji mi se samo jednom dogodio je da nakon duljeg puta sam ugasio auto i nisam ga mogao upaliti jedno 15 minuta dok se nije ohladio.
Novi Delphi senzor me je izasao 50€, u ovlastenom je skoro duplo skuplji.
Senzor se nalazi s prednje strane motora, odmah pored zvona mjenjaca i crijeva od intercoolera.
As it got cold, the crankshaft sensor (rpm sensor / crankshaft sensor) started to fail, so it was my turn. Since I decided to change it myself, and I did not find too much useful information on the Internet, I decided to make this guide in case someone has the same problem.
Symptoms of a bad sensor are a healthy start / up, but it doesn't want to work. Another symptom that only happened to me once was that after a long trip I turned off the car and couldn’t start it for 15 minutes until it cooled down.
The new Delphi sensor cost me € 50, in the authorized one it is almost twice as expensive.
The sensor is located on the front of the engine, right next to the transmission bell and the intercooler hose.
Drzi ga jedan torx saraf, ali prije nego se on odsarafi trebalo bi skinuti dzek. Ovo sto se vidi zuto na slici je osigurac koji se treba povuci prema gornjoj strani da se moze izvuci.
It is held by a torx saraf, but before it is unscrewed, the jack should be removed. What looks yellow in the picture is a fuse that needs to be pulled towards the top so that it can be pulled out.
Novi senzor treba pazljivo staviti u rupu i tek kad se zasarafi prikopcati dzek i to je to.
The new sensor should be carefully placed in the hole and only when the screw is fastened jack and that's it.
Sad nakon izmjene je upalio na prvi zub, bez ikakvih problema. Sve skupa posao traje 15-20 minuta, vjerujem da uz kanal ili dizalicu mozda i manje.
Now after the change he inflamed his first tooth, without any problems. All together the work takes 15-20 minutes, I believe that with a canal or a crane maybe less.
Pozdrav od Mrkija 🇷🇸 - Greetings from Mrky 🇺🇸
DO NOT FOLLOW any instruction and DO NOT CLICK on any link in the comment!
Ok.thank you very much
You're welcome @mrki-car. Stay cautious!
Thank you very much. I'm trying. I'm glad you think so