Today, we will teach you to fold crabs. If you like this kind of guy who is full of fearlessness, you can now pick up the handmade paper to make the handmade origami crab. This handmade origami crab is very similar to the origami spider, and it does make some simple changes based on origami spiders. However, the unobtrusive feeling of crab is still very obvious and outstanding. It is worth making a try by yourself!
朋友们今天小编教大家折螃蟹啦，在沙滩上面横行无阻的螃蟹，如果你也喜欢这种充满着“无畏”的家伙的话，现在就可以拿起手边的纸来制作这个手工折纸的螃蟹。这个手工折纸的螃蟹和折纸蜘蛛非常的相似，也确实是在折纸蜘蛛的基础上做了一些简单的改动，不过螃蟹那种横行无阻的感觉还是非常明显和突出的，值得亲手制作试试看哦！
................................................. ................................................. ....................
It is also handy to have the colored side of the paper face up first if you are working with white paper directly (the origami crab paper pattern is on the last page of this tutorial). According to the origami illustration, the diagonal is folded into a peak mark, while the horizontal and vertical lines are folded into valley marks, and the creases are made to restrain the paper.
1.首先将有纸张有色彩的一面朝上，如果直接使用白色的纸张来进行操作也是非常方便的（折纸螃蟹纸张图案在本教程的最后一页）。根据折纸图示，将对角线折叠为峰痕，而水平和垂直线折叠为谷痕，折痕制作出来后还原纸张。
Then, fold the four corners in the middle of the paper.
2.然后将四个角向纸张的中间进行折叠。
Flip the origami model.
3.翻转折纸模型。
According to the illustration, the diagonal is made into a peak mark, and the lower left part and the upper right part of the diagonal are folded in half to make two valley marks horizontally and vertically.
4.根据图示，将对角线制作成峰痕，对角线的左下部分和右上部分向一起对折，同时制作出水平和垂直的两个谷痕。
Then turn the right corner of the upper surface of the origami model indicated by the yellow arrow to the left, and fold it to the middle.
5.然后将黄色箭头所指的折纸模型上表面的右角向左边翻折，翻折的幅度到中间位置即可。
Press the small yellow arrow in the direction of the origami icon again to crimp it down and flatten it. At this time, the sides pointed by the thick yellow arrows start on both sides.
6.再按照折纸图示中小的黄色箭头所指的方向，向下进行压折，并将其展平。这个时候左右两边的黄色粗箭头所指的边会向两边展开。
The previous step of flattening the left and right sides of the quadrangle produced by the fold in the middle of the fold.
7.将前一步压展平整制作出来的四边形左右两个角按照图示中的折痕向中间进行对折。
This time the middle of the origami model to expand the structure.
8.这个时候将折纸模型中间的结构展开。
Then the yellow arrow refers to the edge of the fold down, fold according to the middle marked creases to operate.
9.再将黄色箭头所指的边向下翻折，翻折根据中间标示出来的折痕进行操作。
Then flatten the four sides of the four yellow arrows.
10.然后将四个黄色箭头所指的四个边压展平整。
Next, fold the triangle under the purple crease up.
11.接着将紫色折痕下方的三角形向上翻折。
Fold the other three corners of the entire origami model as you did in steps six through eleven.
12.将整个折纸模型相对应的另外三个角也按照第六步到第十一步的操作进行折叠。
Then the top corner of the origami model, the angle indicated by the end of the yellow triangle, is pulled to the left and right.
13.再将折纸模型的顶角，即黄色三角形末端所示意的角向左右两边拉开。
Then fold the triangle above the purple peak mark inside.
14.然后将图示中紫色峰痕上面的三角形向内翻折。
Then fold the corner pointed by the yellow arrow backwards. That is, restore the folding of the thirteenth step.
15.接着再将黄色箭头所指的顶角向回折叠。即还原第十三步的折叠。
Fold the other three sections of the origami model in the same way as steps 13 to 15.
16.将折纸模型中相对应位置的另外三个部分按照第十三步到第十五步的方式进行折叠操作。
Follow the vertical creases in the illustration to fold the origami model to the center on either side. Do not fold too much.
17.再按照图示中的垂直折痕，折纸模型左右两边向中间进行对折。折叠幅度不用太大。
Loosen the area pointed by the arrow (the upper surface of the origami paper).
18.将箭头所指的区域（折纸模型上表面纸张）松展开。
Then, fold the origami model in the upper and lower regions according to the folds in the illustration.
19.然后再将折纸模型按照图示中的折痕进行上下区域的对折。
Then fold the triangle in the lower half of the origami fold up by crease.
20.再将折纸模型下半部分的三角形按照折痕向上翻折。
Also operate the other three corresponding positions in the origami model as steps seventeen through twenty.
21.将折纸模型中其他对应的三个位置也按照第十七步到第二十步的方式操作。
Double-fold the two sides of the triangle marked by the middle fold in the origami illustration to create the style as you saw in step twenty three.
22.将折纸图示中中间折痕所标示的两边三角形对折，形成如第二十三步所见的样式。
Then flatten the edge of the yellow arrow.
23.然后再将黄色箭头所指的边压展平整。
The structure on the back of the origami model is also manipulated in the styles from the twenty-second step to the twenty-third step. Flip the origami model.
24.将折纸模型背面的结构也按照第二十二步到第二十三步的样式进行操作。翻转折纸模型。
Trim up the lower triangle crease.
25.将折痕下部的三角形向上翻折。
Then left and right creases below the two triangles folded to the left and right sides open.
26.然后再将折痕下方左右两个三角形按照折痕向左右两边折叠开。
Then the yellow arrow refers to the triangle under a downward pressure fold, fold the attention of two creases in the form of acute angle with the folder, which is below the peak marks, and the top of the valley marks, after making The style of the twenty-eighth figure can be seen.
27.接着将黄色箭头所指的三角形进行一个向下的压折，压折的时候注意两条折痕以锐角的形式相夹，其中下方的是峰痕，而上方的为谷痕，制作后的样式可见第二十八的图。
The triangle to the left is also folded in accordance with the twenty-seventh step of the operation. Then at this time the yellow arrow refers to the upward triangle folded to the left and right sides, the same way with the twenty-seventh step. The figure shows the location of creases with small triangles.
28.将左边向上的三角也按照第二十七步的操作方式进行压折。再将这个时候黄色箭头所指的向上的三角形向左右两边压折开，操作方式同第二十七步。图示中用小三角形表明了折痕出现的位置。
Flip the origami model.
29.翻转折纸模型。
Then fold the triangle pointed by the yellow arrow downward at the same time as the twenty-seventh step.
30.然后将此时黄色箭头所指的三角形向下进行压折，方法同第二十七步。
Fold the end of the previous operation triangle forward.
31.将前一步操作三角形的端部向前进行折叠。
Press the apex of the yellow arrow inwardly into it.
32.将黄色箭头所指的顶角向内压折进去。
At this time, a newly formed inner corner (indicated by the yellow arrow) is once again folded inward.
33.这个时候对新形成的一个内角（黄色箭头所指）也再度向内进行压折。
Fold the outer edge of the origami model pointed by the yellow arrow inward.
34.将黄色箭头所指的折纸模型外缘部分向内压折。
Flip the origami model.
35.翻转折纸模型。
Then fold the two edges pointed by the yellow arrow inwards. The remaining five legs are also handled in the same way.
36.然后将黄色箭头所指的两个边向内对折。剩下的5个腿也按照相同的方式进行处理。
Then fold the top of each leg inward.
37.再将每一个腿的顶部向内压折。
Then fold the lower corner of the yellow paper under the origami model up and fold it up to the position indicated by the yellow arrow.
38.然后将折纸模型下部黄色箭头所指的底角向上翻折，向上翻对折到上部黄色箭头所指的位置。
Such a handmade origami crabs to complete slightly!
39.这样一个手工制作的折纸螃蟹就完成咯！
This crab is so good! Do you want to do one too? Follow the method below can do oh!
这只螃蟹好神气啊！想不想也做一只？跟着下面方法做就可以哦！
Upvoted ☝ Have a great day!
☺