TinkerCad is a good place to start. It has all the basic geometric shapes and ways to edit them. FreeCad might be better if you want to design something complex and precise, but again, it has a steep learning curve.
You are viewing a single comment's thread from:
I will check out FreeCad too. Thank you for the information, I appreciate all the help
@bpcvoter3, sorry! You need more $IDD to use this command.
The minimum requirement is 50.0 IDD balance.
More $IDD is available from Hive-Engine or Tribaldex
@bpcvoter3, sorry! You need more $HOP to use this command.
The minimum requirement is 1.0 HOP balance.
More $HOP is available from Hive-Engine or Tribaldex