How to sew a half circle skirt out of panels

neumannsalva (69)in #needleworkmonday • 7 years ago (edited)

This time you will not laugh at me - no humour in this post - only success :-D

Design ohne Titel(30).png

I will show you an easy method to sew a panel skirt. If you want to skip my fantastic story why I made this skirt and only want to read the tutorial, jump to the headline “the actual tutorial”.

By the way, I finished my Miette cardigan, only the buttons are waiting to be sewn on and I think it is wearable. And with “wearable” I mean wearable in a place which is illuminated and populated by people.

Ok, back to the panel skirt. For two years I had an A-line skirt in a very bold blue jeans in my wardrobe, which did not fit. I so loved the jeans colour, that I went into denial and told myself “Someday I will wear this skirt”. And so, it slept in my wardrobe for years. Last weak I tried it on again and with a helpful comment of my husband I accepted: it looked like sh** on me. The waistband was so wide I could put the skirt on without opening the buttons. On the contrary the flare of its A-line form was not wide enough to fit comfortable on my thighs. Overall, it was a combination of marshmallow man and sackcloth. Time to say goodbye. I gifted the skirt a good friend who has a less ~~huge bottom~~ curvy figure and she loved it. But I immediately needed a replacement (if you could see my wardrobe you would laugh aloud or recommend therapy – something like “declutter for the absolute beginner” or so)

The replacement should have a quite similar colour, but a much better fit. Next step: the fabric store. I bought a nice steal blue slightly stretchy jeans fabric. Unfortunately, it was not so cheap, so I bought less than I would normally buy for a half circle skirt. Very clever, if you want to make a half circle skirt….
At home after a coffee I finally understood what I had done: not only I had saved money, I also had bought too little fabric.

Nooooooooo…… but yes.

After helping my brain with more caffeine, I searched my store-bought skirts and noticed that they are mostly made of panels. I calculated weird mathematical equations in my brain (reality: I fumbled along with skirts and fabric till everything fitted) and understood: smaller panels, less fabric.

Design ohne Titel(31).png

My go to pattern for a half circle skirt consist out of three parts, the front, the back, and the waistband. Now I would make four panels and no waistband. I could fit the four panels in opposite directions on the rectangular fabric so that always the widest part of one panel is beneath the smallest part of the next panel. This is possible, because the jeans fabric has no pattern and I did not mind if the fabric direction is not the same.

The actual tutorial
I made the panels by using an existent store-bought skirt. I put it on a newspaper and copied its outlines. I added seam allowances to this pattern and cut it out. Now I fitted the panels on my jeans fabric. Here you must pay attention to the stretch of the fabric. The panels should be so aligned, that that the waist is parallel to the stretch of the fabric. Check if all four panels fit on the fabric. Next step is putting weights on the paper pattern and then copy the outlines with chalk on the fabric, or if you are bold or lazy like me, simply cut the panels out.

Design ohne Titel(36).png

The next step is so boring… but with jeans fabric there is no way around: seaming all of the edges to stop fraying.
Now put the right sides of two panels together, waist on waist and pin one side together, then sew it. Repeat with the other panels but leave the last seam open and test if the skirt fits. If all is well, you can proceed to the waistband.
To save further on the fabric I made a waistband out of an elastic, that I folded over. Therefore, I cut a 4 cm elastic band in length of my hip, because I wear my skirts very low, to avoid belly ache (I really hate belts….). The length of the elastic band should be a little bit smaller than your actual measurements - but do not forget to calculate a seam allowance. Now sew the elastic into a ring. This ring will now be sewn right side to right side on the waist of the skirt. Therefore, you must measure and mark four points (middle of the front and back and the sides). These for points need to be pinned on the skirt. To achieve this, you must stretch the elastic a bit. Afterwards you can put some more needles in, so that sewing it on becomes easier.

Design ohne Titel(37).png

If you want, you can stop here, and you will get a perfectly functionable skirt with a waistband. But I did not like the black elastic with the blue fabric, so I folded the elastic into the fabric and ironed it brutally…. To secure this fold I made four small seams at the already existent panel seams to attach the fold to the skirt. Now the elastic is invisible. Victory…. :-D

Design ohne Titel(34).png

But stop, the last step is missing, the hem: instead of folding the hemline two times, I used a colourful bias band which I folded into the skirt, ironed, and pinned it and then sewed it on. Tadaaaaa: the panel skirt

My super creative friend Silvia Szlapka made the photos. You can see me worship my new blueberry lip balm, which happened to be in my bag.

Uhhhh before I forget: between the 22.5 and 31.5 I cannot comment or write a post - sorryyyy (and please do not forget me)

Want to see more_Follow me neumannsalvaor visithttp___neumannsalva.de_(1).png

#tutorial #sewing #fiberartists #knowledge

7 years ago in #needleworkmonday by neumannsalva (69)

$19.50

Sort:

Trending

[-]

tali72 (68) 7 years ago

Oo! it's very insulting when the thing you like does not fit. I often have the same problem: the belt is too wide and in the hips too narrow :) you sewed a beautiful skirt! with such a detailed description, even I probably could sew a similar thing too :)